rc connectors*rc plug*RC FPV Cable|RC Connector*RC Connectors,FPV Cable,GoPro HD FPV Cable,Servo Wire
  • Multi-Rotor
  • UBEC¡¢Navigation Light...
  • Safe ParaBoard
  • Tools
  • Connector
  • Cable * Other materials
  • RC Switch & Battery Box
  • Coax Cables & Antennas
  • Adaptor
  • Radio Controlled Micro connec...
  • Battery Lead
  • Charger Leads
  • = Conversion Connector
  • Extension Wire
  • + Parallel Wires
  • * Serial Harness
  • 1 to X Wire
  • Light Cable
  • Multi-Rotor  |  UBEC¡¢Navigation Light...  |  Safe ParaBoard  |  Tools  |  Connector  |  Cable * Other materials  |  RC Switch & Battery Box  |  Coax Cables & Antennas  |  Adaptor  |  Radio Controlled Micro connec...  |  Battery Lead  |  Charger Leads  |  = Conversion Connector  |  Extension Wire  |  + Parallel Wires  |  * Serial Harness  |  1 to X Wire  |  Light Cable  |  
    UBEC  |  Navigation Light  |  Lighting Alarm System  |  Voltage Display  |  Pan-Tilt  |  Servo Tester  |  
    Categories Item No. Select
      Pan-Tilt  X650
    Wireless Voltage Display   Voltage Display  Wireless Voltage Display
      Pan-Tilt  PT-2810
    Description :
Temperature probe for lipo balance charger, such 
as: Imax B5 B6 and other lipo battery balance charger   Voltage Display  Temperature Probe
    10cm 14AWG silicone wire(0.08) + Male T Plug + PE Heat shirink tubing   Pan-Tilt  Distribution Board
    KNT 5A UBEC is a switch-mode DC-DC regulator supplied with a 2-6 cells lithium battery pack (or 5-24 cells NiMh /NiCd battery ) and it outputs a consistent safe voltage for your receiver, gyro and servos. It is very suitable for RC helicopter.   UBEC  5A UBEC
    Switch mode technology offers much great efficiency than linear regulators, which gives you longer battery life.  Integrated noise reduction circuits and a shielded housing reduce any interference-production noise.   UBEC  3A UBEC,Max 5A
    5A UBEC MAX 7.5A
    1.working modes: Standalone
2.LED : 1W
3.Voltage : 4-6V
4.Current Consumption : 20mA
5.Flash : 6
6.Wire : 45cm ¡¢26AWG
7.Color(selection) :  White ¡¢ Red ¡¢ Blue ¡¢ Green ¡¢ Orange   Navigation Light  Navigation Lights(Standalone)
    1.working modes: RC Mode
2.LED : 1W
3.Voltage : 4-6V
4.Current Consumption : 20mA
5.Flash : 6
6.Wire : 45cm ¡¢26AWG
7.Color(selection) :  White ¡¢ Red ¡¢ Blue ¡¢ Green ¡¢ Orange   Navigation Light  Navigation Lights(RC Mode)
    Output : 5V/6A or 6V/6A (Changeable with a jumper),Burst output Current£º8A (¡Ü15 Sec); 

Input: 7-25.5V (2 to 6 cells Lipo battery pack, 6 to 16 cells NIMH battery pack) ;

Ripple: £¼45mVp-p(@2A/12V) ; 

Size : 40mm*23mm*6mm (L*W*H) ; 

Weight : 14.2g(Including the cable and the ferrite ring);   UBEC  6A UBEC
    Voltage Range : 5v-6v
Size :35.5mm*31.5mm*9.5mm (L*W*H) 
Weight :7.8g (for the LED System Control Board)
Light Cable:28AWG Silicone Wire   Navigation Light  LED System For R/C Car
      Lighting Alarm System  Lighting Alarm System
    It can connect 1-3 servos simultaneously and test such as 1-3 servos consistency and so on.

You can also connect 1-3 ESC to test and compare their reaction time respectively.

It can connect 3 servos of the CCPM helicopters and select servos.

It can also connect the servo of airplanes install the steering-box and adjust planes by using such    as the neutral mode and so on.   Servo Tester  Servo Tester